Super easy bracelet made of soda can top pieces. Big plus for being good to the environment!
To make it, you'll need a bunch of soda can top pieces and a piece of ribbon that goes around your wrist three times.
Start with pulling the ribbon through the holes in one of the soda can tops. Make sure to leave the loose ends equally long.
Now place another piece on top of the first one, a little to the left. Pull the ribbon through the holes. Then place a piece to the left of the second one. Pull the ribbon through both of the pieces, as shown.
Continue with placing pieces under and over the already used pieces. Stop when the bracelet is long enough to go around your wrist.
Tie a knot in the end. Use the loose ends to lock the bracelet. Done!
This simple long pendant necklace is just perfect! And the best part, you can make any figure you'll like :)
| To make this necklace, you'll need:
- Some hard plastic, for example an old plastic packaging
- Pins
- Chain and a jump ring
- Glue
- Tools | Prepare the pins by cutting of the sharp part of thee pins with a plier. Make sure you leave no sharp edges.
Also make sure the surface you're working on can handle some spilled glue. | Find out what kind of pattern or figure you want, and lay them as you wish on your surface. |
| Cut out a piece of the plastic. Then simply glue the pins on to it as you like. Make sure the glue is ment for plastic and metal.
When the glue is dry, take a pin or some other thing that's sharp, and make a hole just over the pendant. Then carefully cut out the pendant with scissors or a knife. Attach the pendant to a jump ring and a chain.
That was simple, right? :) | | |
RSS Feed